Hood Tube Frame Mod One of the first things you notice on a replica is the underside of the hood. Original cars had a 3/4″ tube frame with an aluminum skin attached to it. Replicas – not so much. I obtained the upper skin of the Hurricane fiberglass and thenContinue Reading
One of least replicated items of the 427 is the secondary air bleed line on the coolant reservoir. I can’t say I’ve ever seen a replica with one yet every original had them. I am adding features like this to my new build, to go that extra step onContinue Reading
Sorry, been a little remiss in keeping my progress reports up-to-date. I’ve incorporated a number of modifications to my Gen II Hurricane build, mostly to make it even more period correct. Looking at the originals and the ERA builds, I liked the removeable transmission tunnel. The Hurricane comes with aContinue Reading
When Ford designed the S550 driveline, they chose to use a ‘Guibo’ joint just ahead of the differential. Probably done for Noise/Vibration, it just adds another joint when adapting to our toys. Depending on whether the diff came from a manual or automatic vehicle, the joint was a different size,Continue Reading
In the process of developing a brake set for 15″ pin-drive wheels, I was introduced to the world of brake rotors and brake hubs. No more single cast units, no more factory stock units. I chose Wilwood as a supplier and as I got into it, I learned there areContinue Reading
Third time is a charm. Plastic tank, aluminum tank, mod’d aluminum tank and now a redesigned aluminum tank. Some fitment challenges but more trunk space, more fuel capacity and an improved view from the rear. Check this out: Fuel Tank Mod’sContinue Reading
The original Hurricane build used a polyethylene tank by Tanks, Inc. – serviceable but it left a little to be desired. It was very difficult to get it to seal up completely. Builders of the first kits investigated various aluminum replacements. The Gen II cars came out with the firstContinue Reading
It’s rare that you get a do-over. After driving HM1078 for over 8 years, I still had the hankering to do another build. A little bit of work, some great support and guess what – I get to do it again! Working with Hurricane Motorsports, I have an opportunity toContinue Reading
When I received my body, the gelcoat was in excellent shape. But as I began to work on it, I learned although the body looked good, the edges were horrendous. The glass cloth had separated, or wasn’t filled, there were all kinds of voids. No where near ready for finalContinue Reading
Extending the edgesAfter I positioned my body, I learned the opening for my side pipes was not correct. I would have to gain more clearance on the rear but I would have to extend the forward edge back. Extending the edge concerned me since it was cantilevered. I did someContinue Reading