When I received my body, the gelcoat was in excellent shape. But as I began to work on it, I learned although the body looked good, the edges were horrendous. The glass cloth had separated, or wasn’t filled, there were all kinds of voids. No where near ready for finalContinue Reading
Extending the edgesAfter I positioned my body, I learned the opening for my side pipes was not correct. I would have to gain more clearance on the rear but I would have to extend the forward edge back. Extending the edge concerned me since it was cantilevered. I did someContinue Reading
The body I received was very high quality – on the outside. The inner edges left a lot to be desired. Two issues; 1) voids in gel coat and underlying glass had to be repaired to insure integrity of the finish and 2) I knew that people would be feelingContinue Reading
Fiberglass is Fiberglass The title is mis-leading. Yes, fiberglass is fiberglass but is it poly, vinyl or epoxy? And within a family, are various brands compatible? Fortunately, building two fiberglass cobras prior to tackling the GT40, I had some fiberglass experience. The good part is the GT40 was originally fiberglassContinue Reading
HM1078 Mod’sMy car included the revised lower body panel, relocated roll bar, relocated louvers and rear wheel well depression, all changes in design by Hurricane to improve the kit. I have added these NOTE: The Hurricane kit builds perfectly fine on its own. I just like the idea, “If itContinue Reading
I’ve heard horror stories about registering a kit car. Wanting to head them off at the pass, I visited Troop C in Chesterfield, MO to discuss the requirements. I’ve learned so far: Note: these steps apply to a ground-up build. There are shortcuts available to those using a donorContinue Reading
Spindle Replacement The tapered joints of the balljoint are pulled into the spindle with 100 ft/lbs of torque. These joints are tight! To remove or replace parts, some recommend putting a pickle fork tool between the ball joint and hit it with the biggest hammer you can find. I wasContinue Reading
Wheel alignment “Stringing” a car is the way racer’s do wheel alignment. You don’t need a fancy (expensive) computer aligner if you are willing to do some setup and understand basic measurements. Setup: Prior to starting the alignment process, you need to determine the desired ride height of the vehicle.Continue Reading
FE References As I searched for info on my build, I have come across a number of articles and references for the FE afficianado. I have taken the liberty to combine some of the pages into one downloadable PDF, giving credit where due. Did this, just in case the webserversContinue Reading